Started a new Dome print!

I ended up messing around with the firmware for the MPCNC... I know I need to correct the "ringing" that is occurring due to vibrations hardware wise... but until then I slowed it down a bit.

I reduced the jerk from 4 to 2
I reduced the acceleration on x/y from 400 to 200

Viola!  Better print... howbeit 30+ hours each.

If you look close... ok ok.. yes its blue... wont matter since I have to paint it anyways so hush!

The lines are greatly reduced and ringing is almost not existent...

Another shot of it... I think I will use this once its done.. we are on hour 28 and counting... of the print.